How do I get a replacement key for my Craftsman toolbox?

Order your Craftsman replacement toolbox keys by selecting your lock code from one of the available Craftsman lock series below. The lock code determines the correct key for your lock and will be stamped on your key or the face of your lock if you have lost your keys.

How to Replace a Lock on a Craftsman Toolbox

  1. Look for the white model number/serial r sticker on the back or bottom of the toolbox.
  2. Use a drill and drill out the rivets until you free the lock from the toolbox frame.
  3. Open the toolbox and empty all cabinets, drawers and containers.
  4. Position the new lock over the place where the old lock was attached.

Also Know, how do you pick a barrel lock? Insert the pick into the lock slowly, allowing the picking needles to map to the corresponding pin stacks. Slowly apply left to right turning torque to the pick and the lock should pop open. Once the lock is picked, remove the tubular lock pick and tighten the collar.

Hereof, how do I identify my Craftsman tool box?

The model number on a tool box is normally located inside the bottom drawer. If this is a tool chest, it will be under it. It is possible, that because of it age that the diagrams you need are no longer available.

How do you remove a Craftsman toolbox drawer?

How to Remove Drawers From a Craftsman Tool Chest

  1. Open the drawer you want to remove and empty the contents.
  2. Pull the drawer out until it extends fully. Look on the side rail to see if you have a lever or tabs.
  3. Press the tabs on each side with your fingers, if your drawer uses tabs instead of levers. Pull the drawer completely out of the tool chest.

How do you drill out a lock?

Part 2 of 2: Drilling the Lock Drill a hole through the lock cylinder through the guidance point. This destroys the pins inside the lock cylinder, allowing you to force the lock open. Go slowly. Switch to a slightly larger bit. Insert the blade of a flat-headed screwdriver into the lock head. Improvise if necessary.

How do you remove snap on drawers?

How to Remove the Drawers From a Snap-On Toolbox With Ball Bearing Slides Open the Snap-On toolbox drawer and remove the tools from the drawer. Press the end of the clip tab up on one side with a flat-head screwdriver and pull the drawer until the inner slide stop is past the clip.

How do you hack into Snap On Tool Boxes?

How to Break into a Snap-On Tool Box Pry the top drawer of the toolbox down slightly with a crowbar. Slide a long, thin piece of metal into the opening made by the crowbar. Jimmy the metal piece so it shifts under the lock bar in the back of the box.

Who makes Craftsman tool cabinets?

Craftsman (tools) Product type Hand tools, power tools, lawn and garden equipment, work wear Owner Stanley Black & Decker Country United States Introduced May 20, 1927 Related brands Evolv, Craftsman Professional, Craftsman Industrial, Companion, Dunlap

Who made Craftsman tool boxes?

Craftsman tools are also manufactured by APEX tool group, US. The Company was recently acquired by Bain Capital and like many other industries in the region, it also focuses on outsourcing. And China being the main source, it is most likely that the tool chest made by the firm originates from China.

Are truck cap replacement keys?

Tonneau Covers and keys for A.R.E. Truck Caps. Many handles are not marked with the key code which should be located on the face of the lock. If it is not there there is no need to take the lock off unless you want to send it to us to have a key made.

How do you remove a toolbox lock on a truck?

For metal toolboxes, use a screw driver to remove the old lock. Apply some force as the screws may be tightly fixed to the box. There are tool box that have locks fixed using bolts. Use a pair of pliers to unlock the bolts from the box.